Do this on the Home Assistant SD card’s first, bootable partition (labeled “hassos-boot”, It might not be auto mounted in Linux) then create a new file called my-network in the CONFIG/network/ folder. This will allow the IP of Home Assistant not to change. Set up a static IP address and/or Wi-Fi Network. We recommend at least a 32 GB SD card to avoid running out of space. Raspberry Pi, Raspberry Pi Zero-W, Raspberry Pi 2įlash the downloaded image to an SD card using balenaEtcher.Raspberry Pi 4 Model B (1 GB, 2 GB 4GB and 8 GB model) 64-bit (64-bit is required for 8 GB model).Raspberry Pi 4 Model B (1 GB, 2 GB and 4 GB model) 32-bit (32-bit is required for GPIO support).32-bit -Raspberry Pi 3 Model B and B+ (32-bit is required for GPIO support).– Raspberry Pi (4 GB Model recommended) – 32 GB Micro SD card (Must be class10) – balenaEtcher( To write image to SD Card)ĭownload the appropriate installation image option for your device: Optimized for embedded devices like Raspberry Pi.
We will take you through the steps required to install Home Assistant. With Home Assistant, you can focus on integrating your devices and writing automations. Home Assistant turns your Raspberry Pi into the ultimate home automation hub.
0 kommentar(er)
